User`s guide

11
Compound Bow
USER’S GUIDE
MACH X
The X Technology bows come with many unique features that will
enhance your archery experience.
MULTI POSITION SIGHT MOUNTING
The Mach X bow is equipped with a multi-position sight-mounting
feature allowing the sight to be mounted to optimize your sight
window. Mount the sight in the middle position and sight in the bow.
Your pin grouping should be centered on the sight body. If the pins are
too high, move the sight to the upper mounting position. If they are
too low move the sight to the lower position. Sight in the bow again.
INDEPENDENTLY ADJUSTABLE PIVOTING
POCKET SYSTEM
The X Technology bows are equipped with an innovative limb
pocket system.
Do not make any adjustment to this system without referring to the
instructions in this manual.
MAINTENANCE
Your bow is a mechanical device that is subject to wear and therefore
must be inspected periodically and given the proper adjustments and
service. It is recommended that this service be performed at least
once a year by an authorized PSE dealer. All components, including
string, cable, axles, e-clips, limbs and riser should be carefully
inspected for damage or wear.
USING A BOW PRESS
Use only a PSE approved bow press to service an X Technology bow.
Never allow your bow to be placed in a bow press with conventional
rollers. Check our website (www.pse-archery.com) for a current list of
approved bow presses.
STRINGS AND CABLES
Apply a light coat of high quality bowstring wax to your string and
cable once every two weeks under normal shooting conditions. It is
especially important to wax the area of the string that wraps around
the idler wheel since this portion of the string is not served. This will
help reduce wear on your string and cable. Use a good quality wax
from your authorized dealer. Inspect the string and cables regularly
and replace them when there is evidence of wear.
LUBRICATION POINTS
When removing the limbs for service always make sure that the area
between the half rounds and the limb pockets are lubricated with
medium-weight grease. Also lubricate the surfaces in the pocket
areas where the limbs make contact with the riser with the same
grease.
ADJUSTING LIMB BOLTS
Before making any adjustments to the limb bolts, the 4 side locking
tab screws and the 4 limb bolt locking screws must be loosened (see
Figure 2). Limb bolt adjustments must be made in increments of no
more than one-turn each. There should never be a differential of
more than 2 turns at any time between limb bolts. After limb bolt
adjustments are complete tighten the 4 locking tab screws and the
4 limb bolt locking screws.
Start with the sight
mounted in the middle
set of holes
A typical bow press will damage X
Technology bows. DO NOT USE
!
Place roller
close to the end
of the limbs
PSE Approved Bow Press
Limb Pocket
Half Round
Alignment
Pins
Underlay
Figure 1