Specifications

Programming Parameters
E-4 Falcon
®
PT40
Alternate Parameters for the Falcon PT40
Enter these commands by scanning the bar codes with the PT40’s laser or
through the PC’s serial port. With PT Program Generator (PPG), you can
embed these codes in a PPG application.
The Falcon PT40 recognizes the following bar code commands at all times:
Table E-3. Scannable Bar Codes of Alternate Settings for the PT40
Scannable Bar Codes of Alternate Settings for the PT40
Setting Name Bar Code Description
Clear Mode
*--*
Has the same effect as the <CLR> key
Character
Clear Mode
*-+*
Has the same effect as the <CLR> key for the last char-
acter entered.
High Beep
Mode
*.+*
Sounds a high beep on the PT40.
Low Beep
Mode
*.-*
Sounds a low beep on the PT40.
Receive File
Mode
*/.*
Prepares the PT40 to accept a program.
Retrieve Data
Mode
*$$*
Retrieves data if the application program stops execution
and gives the
PROGRAM FAILED message. Connect
the PT40 to the PC and start the communications pro-
gram on the PC, then scan this bar code. The data will
transmit, one file at a time.
CAUTION
Reset Mode
*+.*
Clears all memory and resets the PT40.
2340.book Page 4 Wednesday, January 29, 2003 12:50 PM