Specifications

Transferring Files and Data
3-4 Falcon
®
PT40
Connection Enter the Connection port for file transfers. Select from the list
of detected serial ports or modems.
Baud Rate Select a
Baud Rate for serial communica-
tions from the pull-down list. The default
value for XFER32 is
19200. The default
value for the PT40 is
9600.
Note: The PT40 supports only baud rates
up to
38400.
Protocol
Select either
XModem or ACK/NAK as
the file transfer
Protocol for sending and
receiving files.
NOTE:
ZModem Protocol is NOT sup-
ported by the Falcon PT40.
NOTE: The PT40 defaults to the
ACK/NAK protocol unless you
select
XModem. XFER32 defaults to the ZModem Protocol.
ACK/NAK and XModem Protocol are the only two protocols
supported by the PT40.
Maximum Errors Enter the maximum number of
Errors permitted before a file
transfer is aborted. Range:
1 to 50. 0 specifies no limit to the
number of file transfer errors.
Flow Control Select the mechanism used to control the
flow of data. Sender and receiver must
agree on the flow control method.
Note:
RTS/CTS is the default. Use either None or RTS/CTS.
XON/XOFF is not supported by the PT40.
None No flow control used.
XON/XOFF
NOTE:
ZModem Protocol is NOT supported by the Falcon PT40.
This feature is only available with
ZModem protocol.
RTS/CTS Hardware flow control that uses
Request to Send (RTS), and
Clear to Send (CTS) serial port lines to communicate when to
suspend and resume data transfer.
Window Size
NOTE:
ZModem Protocol is NOT supported by the Falcon PT40.
This feature is only available with
ZModem protocol.
2340.book Page 4 Wednesday, January 29, 2003 12:50 PM