Specifications

Accessories
Product Reference Guide 1-13
To recharge the PT40’s batteries and for more detailed information about the
main and backup batteries, refer to
Falcon PT40 Batteries on page A-1 and
Using the Dock to Recharge the Main Battery on page B-4.
PT40 Belt Clip
To install the belt clip, complete the following steps:
1. Follow the instructions for
Main Battery Installation starting on page A-3 to
remove the main battery and battery cover door.
Figure 1-5. Belt Clip and Knob Assembly
2. Align the belt clip knob with the slight depression just above the battery
compartment.
• Position the knob facing out and the small clip lined up with the
small slot inside the unit. (
Figure 1-6 shows the belt clip knob)
• Press up firmly on the belt clip to insert it into the slot (refer to
Figure 1-6 for the location of an installed belt clip knob).
3. Replace the battery and battery compartment cover as described in
Main
Battery Installation starting on page A-3.
4. Slip the belt clip knob (refer to
Figure 1-6) into the slot in the belt clip.
5. Attach the belt clip to your belt.
6. To release the unit from the belt clip, press the button at the top of the
belt clip and slip the unit up from the slot.
Belt Clip Knob
Belt Clip
Slot
Release
button
Belt Clip
2340.book Page 13 Wednesday, January 29, 2003 12:50 PM