Specifications

Product Reference Guide 2-19
Unpacking
To unp a c k the u n i t:
• Inspect the package for signs of damage that may have occurred
during shipp
ing. If damage is found, report it to your carrier
immediately.
• Lift out the accessory box containing the AC/DC Power Supply,
optional R
emote Scale Display and cable (if present), and the
Quick Reference Guide.
• Remove the Quick Reference Guide and familiarize yourself with
the un
it’s controls and features. Leave the guide at the checkstand
when the installation is complete.
• Remove the protective packing and carefully lift the unit from the
car
ton. Be sure to save the box and all packing material. In the
event of failure, the unit must be returned to the factory in its
original packaging
.
• Carefully lift off the All Weighs™ Platter as shown in Figure 2-24
and remove the protective foam pieces securing the weigh mecha-
nism.
NOTE
For added protection during shipment, the All W
eighs™ Platter is covered
with a tight-fitting layer of vinyl as shown in
Figure 2-12. This vinyl layer
MUST BE REMOVED before placing the unit into service
.
Set the platter back in place.
Figure 2-12. Remove Protective Vinyl
Protective vinyl
MUST be removed
from the
platter
before use.
(Models vary)
• Proceed to the Operational Verification instructions below.