Specifications

7-188 Magellan

8500Xt Scanner

GTIN Code 128 Supplemental Label ID

This feature specifies a GTIN label ID to be added to barcode data when

GTIN conversion is enabled and Code 128 supplemental addon barcode

labels are converted

NOTE

The programming feature, RS-232 Label ID Control, designates whether

the Label ID is transmitted as a prefix or suffix or if Label ID is disabled.

To set this feature:

1. Scan the SWITCH barcode.

2. Scan the barcode, SET GTIN CODE 128 SUPPLEMENTAL

LABEL ID below. You’ll need to cover any unused barcodes on this

and the facing page to ensure the scanner reads only the barcode you

intend to scan.

3. Scan the appropriate digits from the keypad in

Appendix C that rep-

resent the desired Label ID characters; entered as two hex pairs. A

table con

taining the ASCII Character Set and their corresponding

Hex Values is available in the inside back cover of this manual.

ASCII

parameters must be input by scanning a pair of hexadecimal

digits for each character. Thus, to set a two-character value of AB,

barcodes containing the digits ‘4’, ‘1’, ‘4’, and ‘2’ must be scanned.

The selectable range for this option is any hex value from 00 to FF

(for each of the two characters).

4. Complete the programming sequence b

y scanning the SWITCH

barcode.

SET GTIN CODE 128 SUPPLEMENTAL LABEL ID