Specifications

20
SPEAKER VOLUME PROGRAMMING
The Magellan scanner and scanner/scale allows you
to change the speaker's volume without entering
Programming Mode or using programming labels.
To change the speaker's volume press and release
the speaker switch.
NOTE
Keeping the switch depressed for longer
than three seconds will initiate a scan-
ner reset.
The scanner sounds the next volume setting three
times. There are three volume options available.
Continue pressing and releasing the switch until the
volume level you want is sounded.
If you wish to change the speaker's active default
setting, use the labels on the following pages to
change the speaker volume setting.
NOTE
If this feature appears not to work, the
switch may be disabled. Follow the
normal programming sequence and use
the label on page 17 to enable the
switch and try again.