User`s guide

16 HS1250 User's Guide
POWER-UP PROCEDURE
The system power-up procedure may vary depending on the require-
ments of your Point-of-Sale (POS) system. It is always a good idea to
power-down (switch off) all equipment prior to connecting cables. Check
with your system supervisor and/or refer to the terminal operator's
manual for proper power-down and power-up procedures for your
system.
Before beginning this procedure, disconnect power from the scanner (if
connected).
1. Power-down your terminal.
2. Connect the scanner interface cable to the POS terminal.
3. Connect the IEC power cord to the AC/DC Power
Supply and then to an AC outlet. It is recommended
that the IEC power cord of the AC/DC power supply
be connected to the same AC outlet as used by the POS
terminal.
4. Power-up the terminal.
5. Power-up the scanner.
6. Verify that data is being properly communicated
between the scanner and your POS terminal by scan-
ning a few items.
You have completed the scanner installation and power-up procedures. If
problems occur, follow the procedures titled Problem Isolation on the
next page.
If you want to modify the scanner's interface parameters or change the
user interface (e.g. volume), order the HS1250/VS1200 Programming Kit
(PSC Part Number R44-1340).