User`s guide
Table Of Contents
- Table of Contents
- Introduction
- Product Overview
- Manual Overview
- Operational Overview
- Duet Scanner Controls
- Connectors
- Sleep Mode
- Unpacking
- Verifying Scanner Operation
- Countertop Installation
- Connecting the Scanner
- Troubleshooting
- How To Scan
- Customizing Your Scanner's Operation
- Routine Maintenance
- Appendix A - Specifications
- Appendix B - Regulatory Agency Information
- Stand Installation Template
18
Duet
™ Scanner
2. Mark the hole position and drill two pilot holes,
approximately 1/8 inches (.3 cm) diameter and 3/4
inches (2.0 cm) deep, into the countertop.
3. Install the two mounting screws, but do not tighten.
Leave the heads of the screws approximately 5/16
inches (1 cm) above the countertop as shown in
panel 3 on the opposite page.
4. Place the scanner stand over the two mounting
screws, aligning the large openings with the screw
heads.
5. Twist the stand firmly, but gently, in a clockwise
direction to engage the screws in the baseplate slot.
NOTE
It may be necessary to readjust the height of the mounting screws
to obtain a good fit. The mounting screws should be adjusted
until no up and down movement of the base is detected, but not
so tight as to prevent the base from being removed from the
mounting screws.
6. This completes the stand installation.
You may wish to drill an additional 3/4 inch (2.0 cm) hole near the
scanner for routing the interface cable to the host terminal.