User`s guide
Table Of Contents
- Table of Contents
- Introduction
- Product Overview
- Manual Overview
- Operational Overview
- Duet Scanner Controls
- Connectors
- Sleep Mode
- Unpacking
- Verifying Scanner Operation
- Countertop Installation
- Connecting the Scanner
- Troubleshooting
- How To Scan
- Customizing Your Scanner's Operation
- Routine Maintenance
- Appendix A - Specifications
- Appendix B - Regulatory Agency Information
- Stand Installation Template
14
Duet
™ Scanner
Power-Off-Terminal (P.O.T. Option)
– If your scanner uses Power-Off-
Terminal (P.O.T.), the scanner must be connected to the host terminal
to verify the scanner operation. The P.O.T. option requires an
interface cable designed to supply power as well as transmit bar
code data.
To verify the scanner operation with the P.O.T. option follow the
steps in the section Power-Up Procedures. Then refer to the previous
paragraphs, Passes Selftest or, Fails Selftest, depending on the
scanner’s behavior.
Figure 7. Verifying Scanner Operation
a. Interface Connector d. DC Power Supply Connector
b. Interface Cable e. AC/DC Power Supply
c. Host Terminal Connector*
* Actual Host Terminal connector may vary from illustration.