Specifications

Problem Isolation
4-4 Magellan
®
2200VS/2200VSΩ and 2300HS/2300HSΩ
Flowcharts
The problem isolation flowcharts on the following pages allow you to
identify and troubleshoot problems with your system.
Figure 4-1. Problem Isolation: Start
START
YES
NO
Does
the scanner
power-up
?
YES
NO
Does
the scanner
pass Selftest
?
YES
NO
Is the
Green LED
Lit
?
YES
NO
Is the
Green LED
Lit
?
YES
NO
Will the
scanner read
bar codes
reliably
?
YES
NO
Have you
checked the
power
connections
?
Check these
potential problems:
- AC/DC adaptor
- AC outlet
Power-up
Scanner power-up is signified by
any or all of the following:
- Facet wheel shows movement
- Laser turns on
- Status LED lights
- Speaker sounds tone(s)
Selftest Failure
If the scanner fails its Selftest, the
following takes place:
- Speaker sounds a tone at the lowest
value for approx. 3 seconds.
- LED flashes on and off.
Consult the Selftest flowchart if you're
unsure the unit has passed Selftest.
Flashing Green LED
If the Green LED is flashing slowly, the
scanner is most likely in Sleep Mode.
Press and release the Volume/Tone
Push Button or wave your hand in front
of the vertical window to "wake-up" the
scanner.
A flashing Green LED can also mean
the scanner has been disabled by the
POS terminal. To exit this mode, cycle
power or have the terminal re-enable
the scanner.
For units using an AC/DC adapter, verify that...
1. AC Adapter is connected to a functional AC outlet.
2. Power cord is firmly connected to scanner.
If your unit is a model which receives Power Off the
Terminal POT), verify that the I/F cable is securely
connected at both ends.
AC
Adapter
Go to Selftest
flowchart
Go to Poor/No
Reading flowchart
Ensure the Green LED is
enabled via pro-
gramming bar codes.
Call Tech Support
Other Problems?
Call Tech Support
Scanner