Specifications

Operational Modes
Product Reference Guide 3-5
Error Reporting
If a fatal error is detected during Selftest or operation, the scanner will not
advance to Normal Operation Mode. Selftest diagnostics will cause the
scanner to sound a long, low tone. When this occurs, error codes may be
accessed by momentarily pressing the Volume/Tone Push Button. The
beeper and LED will then emit a coded series of indications to assist the
repair technician in identifying the failed component. If an error is indi-
cated, make note of the tones heard/LED flashes. A table containing a list-
ing of the error codes is included in
Chapter 4.
Operational Configuration
Once Selftest diagnostics have been successfully run, a tone is emitted (if
configured to do so, and the unit enters an operational configuration state.
The scanner will automatically load your specific interface settings which
are required to communicate with the host system.
No bar code label can be in the scan volume while the unit is in this state.
Progress is halted until the label has been removed, thereby ensuring that
no extraneous bar code data is send to the host. When the scanner com-
pletes its Selftest successfully, it emits a tone (when configured to do so)
and enters Operating Mode.
Operating Mode
Operating Mode includes Normal Operation (scanning) and Sleep Mode.
These two modes are most commonly observed by the user/operator.
Normal Operation
This condition is indicated by the green light being on dim and steady.
NOTE
LED indications are configurable. Your scanner may not be pro-
grammed to operate in the standard manner described above.