User guide

ManualsBrandsPS Engineering ManualsAccessories communicationPM1000II 11906

May 2010 Page 1 200-124-0100PM1000II Specialty Intercom Manual Page 1 May 2010

PM1000II

Specialty Panel Mounted

Intercoms

Part No. 11906, 11908 (with Internal Recorder System)

Operator's and Installation Manual

PS ENGINEERING, INCORPORATED

9800 Martel Road

Lenoir City, TN 37772

Phone (865) 988-9800 FAX (865) 988-6619

www.ps-engineering.com

NOTICE: Warranty is not valid unless this product is

installed by an Authorized PS Engineering deale, or a

professionally made wiring harness is obtained from PS

Engineering or an authorized dealerr.

Document Number 200-124-0100

Rev. 3 May. 2010

Sound Quality. Sound Engineering.

Summary of content (9 pages)

PAGE 1
Sound Quality. Sound Engineering. PM1000II Specialty Panel Mounted Intercoms Part No. 11906, 11908 (with Internal Recorder System) Operator's and Installation Manual PS ENGINEERING, INCORPORATED 9800 Martel Road Lenoir City, TN 37772 Phone (865) 988-9800 FAX (865) 988-6619 www.ps-engineering.com Document Number 200-124-0100 Rev. 3 May.
PAGE 2
Section I General Information 1.1 Introduction The PM1000II, is a panel mounted, 4-place monaural intercom system (ICS). Please read this manual completely before installation to minimize the risk of damage to the unit and to become familiar with all the features. 1.
PAGE 3
the following: 1.6 Equipment required but not supplied 2.3 Equipment installation procedures A.Headphones, 150 monaural, up to four as required B.Microphones, up to four, as required C.Interconnect wiring D.Circuit Protection 1 Amp. 1.7 1.Using the template, drill six holes in the instrument panel in a location convenient to the pilot position (s). 2.Insert the PM1000II from behind the instrument panel, aligning the holes for the knobs, LED, and switch. 3.
PAGE 4
To connect intercom into the aircraft audio system, parallel the appropriate set of cables from the intercom to the Auxiliary Aircraft Radio Headset Jacks. Finally, install new headset jacks into the aircraft and connect them directly to the appropriate pins of the PM1000II. See the wiring diagram for all details of the wire harness interconnects. 2.2.2 Power Requirements 2.2.
PAGE 5
on pin 14 of the connector, and airframe ground on pin 1. Failure to do so will cause internal damage and void the warranty. 1. Apply power to the aircraft and avionics. 2. Plug headsets into the pilot, copilot and passenger positions. 3. Verify that the pilot can transmit and receive with the PM1000II in the OFF position (pilot volume knob fully counterclockwise). 4. Rotate the pilot volume clockwise, about half way. Verify that the Pwr/Xmt light comes on, and shows green.
PAGE 6
channel closes. This prevents squelch closure between words, and helps eliminates choppy intercom conversations. 3.3 Intercom Mode Select The center switch is a three position mode control that allows the pilot to tailor the intercom function to suit flight conditions. Regardless of configuration, the pilot will always hear the aircraft radio. NOTE: If there is a power failure to the PM1000II, or if the power switch is turned off, the copilot will not hear the aircraft radio.
PAGE 7
PM1000II NO crew, p/n 11906 11906 Sub-D DB-25-- Unit has female (socket) 1A 14 11-33 VDC 1 Power In Ground To Aircraft Radio Phone Hi A/C Radio Phone Audio Hi A/C Radio Phone Audio17 Lo AUX Headphone Jack 4 To Aircraft Radio Phone Low Aircraft Radio PTT12 Aircraft Mic Audio Hi 25 Aircraft Mic Audio Lo Aircraft Radio PTT AUX Mic Jack 13 Copilot, Pax 1 & 2 Phones Hi 19 Copilot, Pax 1 & 2 Phones 6Lo To Aircraft Radio Mic Audio Lo To A/C Radio Mic Audio Hi Copilot Phones Pilot Phone Audio Hi 18 P
PAGE 8
PM1000II With Crew p/n 11908 11920 Sub-D DB-25 Female (Sockets)1Aon unit 14 11-33 VDC 1 Power In Ground To Aircraft Radio Phone Hi A/C Radio Phone Audio Hi A/C Radio Phone Audio 17 Lo AUX Headphone Jack 4 Aircraft Radio PTT 12 Aircraft Mic Audio Hi 25 Aircraft Mic Audio Lo To Aircraft Radio Phone Low Aircraft Radio PTT Aux Mic Jack 13 To Aircraft Radio Mic Audio Lo To A/C Radio Mic Audio Hi Pass 1 & 2 Phones Hi15 Pass 1& 2 Phones Lo 2 Passenger 1 Phones Passenger 2 Phones NOTES: Copilot Ph
PAGE 9
PM1000II Part Number 11906________ or 11908_________ Serial Number______________________________________ Purchase Date_______________________________________ Installed by:_________________________________________ 13 12 11 10 9 8 7 6 5 4 3 2 1 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 25 24 23 22 21 20 19 18 17 16 15 14 Ground Power (11-33 VDC) Pass.