User guide

ManualsBrandsPS Engineering ManualsAccessories communicationPM1000 (11909)

Sept. 2007 Page 1 200-125-0100

PM1000II

Specialty Panel Mounted

Intercoms

Part No. 11909 (PTT ICS For open cockpit)

Operator's and Installation Manual

PS ENGINEERING, INCORPORATED

9800 Martel Road

Lenoir City, TN 37772

Phone (865) 988-9800 FAX (865) 988-6619

www.ps-engineering.com

NOTICE: In certified aircraft, warranty is

not valid unless this product is installed by an

Authorized

PS Engineering dealer.

Document Number 200-125-0100

Sept. 2007

Sound Quality. Sound Engineering.

Summary of content (5 pages)

PAGE 1
Sound Quality. Sound Engineering. PM1000II Specialty Panel Mounted Intercoms Part No. 11909 (PTT ICS For open cockpit) Operator's and Installation Manual PS ENGINEERING, INCORPORATED 9800 Martel Road Lenoir City, TN 37772 Phone (865) 988-9800 FAX (865) 988-6619 www.ps-engineering.com NOTICE: In certified aircraft, warranty is not valid unless this product is installed by an Authorized PS Engineering dealer. Sept. 2007 Document Number 200-125-0100 Sept.
PAGE 2
PM1000II with PTT-ICS, p/n 11909 1A Section I General Information 1.1 Introduction The PM1000II, is a panel mounted, 4-place monaural intercom system (ICS). Please read this manual completely before installation to minimize the risk of damage to the unit and to become familiar with all the features. PM1000II, p/n 11909, Front Panel 1.
PAGE 3
4.2 the unit off. Factory Service The PM1000II is covered by a one-year limited warranty. See warranty information. Call PS Engineering, Inc. at (865) 988-9800 before you return the unit. This will allow the service technician to provide any other suggestions for identifying the problem and recommend possible solutions. After discussing the problem with the technician and you obtain a Return Authorization Number, ship product to: PS Engineering, Inc.
PAGE 4
. shafts and secure, using the two # 4-40 round head screws provided. Install the knobs over the volume and squelch control shafts. be removed for any reason, these jacks provide access to the aircraft radio system. To connect intercom into the aircraft audio system, parallel the appropriate set of cables from the intercom to the Auxiliary Aircraft Radio Headset Jacks. Finally, install new headset jacks into the aircraft and connect them directly to the appropriate pins of the PM1000II.
PAGE 5
3. Verify that the pilot position can transmit and receive with the PM1000II in the OFF position (left hand volume knob fully counterclockwise). 4. Rotate the pilot volume clockwise, about half way. Verify that the Pwr/Xmt light comes on, and shows green. If the LED is red, stop testing and trouble-shoot the microphone PTT installation. 5. Verify that the pilot can transmit and receive on the com transceivers. 6. Verify that the LED in the intercom changes from green to red when a microphone is keyed. 7.