9800 Martel Road Lenoir City, TN 37772 www.ps-engineering.com PAR100EX Audio Selector Panel High-fidelity Stereo Intercom System VHF Communications Transceiver Controller Flying Never Sounded So Good! ® Pilot’s Guide and Operation Manual 202-760-0100 Revision New March 2010 Covered under one or more of the following Patents No. 4,941,187, 5,903,227, 6,160,496, 6,493,450 Feb.
This section provides detailed operating instructions for the PS Engineering PAR100EX, Audio Selector Panel/Intercom/VHF Communication Control Systems. Please read it carefully before using the equipment so that you can take full advantage of its capabilities. This section is divided into sections covering the basic operating areas of the PAR100EX systems. They are Communications Transceiver Selection, Audio Selector, Intercom, VHF COM, entertainment, telephone, and display.
nications radio is selected for transmit. The top row of pushbuttons (# 3) allows selection of the receiver audio. Push the lower button to select the desired COM transmitter. A green LED above the button illuminates to indicate that the audio is selected. The PAR100EX-Series has an automatic com receiver selector system. Audio from the selected transceiver is automatically heard in the headsets and speaker (if selected).
COM Audio Selector (3) Communication audio from the other radio, not selected for transmit, can be heard by pressing the associated RCV button. You will always hear the audio from the selected transceiver. In SPLIT mode, only the pilot will hear selected navigation audio (A1 & A2). Navaid Audio selection (4) VHF Navigation receiver audio is selected through two momentary, pushbutton, backlit switches. The users can identify which receivers are selected by noting which green LEDs are lit above the button.
Push/hold for more than one second Monitor Mode When interfaced with the M760R VHF COM radio as Com 1, the standby frequency can be monitored by holding the C2 Receive button for the Microair for more than one second (or until the indicator becomes active). Intercom Operation (8) IntelliVox® VOX-Squelch No manual adjustment of the IntelliVox® squelch control is possible. Through individual signal processors, the ambient noise appearing in all four microphones is constantly being sampled.
will not only optimize VOX performance, but will improve the overall clarity of all your communications. Mic Muff ™ Part Numbers Manufacturer Model Mic Muff™ Part Number Bose Dynamic Electret M87 Dynamic 90010 90015 90020 David Clark H10-30 H10-20, H10-40 H10-13.
Quick reference PAR100EX Operation This pull-out section covers advanced operation of the PAR100EX. Frequency Selection Turn the large (outer) knob to change the frequency whole MHz, and the smaller, inner knob to change the .100 MHz frequency. Push the small knob momentarily to transfer standby frequency to the active frequency.
Split Mode The Split mode puts the pilot on COM 1, while the copilot can use COM 2 independently. To enter the split mode, press both the C1 and C2 XMT buttons at the same time. To exit, press the desired COM 1 or COM 2 XMT button. When you activate the Split mode, the intercom is put into ISO modde to avoid confusion with multiple conversations. To reactivate the intercom, select a different intercom mode. Note: Split Mode does not turn off selected radio audio to pilot.
(Continued from page 6) Intercom Modes (8) The “ICS” pushbutton switch on the lower left side of the panel provides the selection of the three intercom modes. The description of the intercom mode function is valid only when the unit is not in the "Split" mode. This button cycles through the intercom modes, from left to right, then right to left as: ISO, ALL CRW and CRW, ALL, ISO. An LED behind the text shows which mode is currently active.
swer the call from your telephone handset. The PAR100EX exits the telephone mode automatically when the cellular phone hangs up. In TELEPHONE mode, the pilot microphone and headphones are connected to the cell phone. The pilot PTT will switch the pilot mic to the selected com transceiver, and allow continued aircraft communications to continue. The copilot will also be able to transmit on the other selected radio with his PTT as well.
MUTE ON: Music will mute with either intercom or radio – MUTE ON button is lit. RADIO MUTE: Intercom will not mute music, radio will mute music. RAD LED indicator is on INTERCOM MUTE: Radio will not mute music, intercom will mute music - MUTE ICS LED is ON. MUTE OFF: “Karaoke” mode - music will not mute except during outgoing transmissions.- All Indicators off.
PAR100EX Serial Number: ____________________ M760R EM COM Serial Number: _______________ Installed by: ________________________________ Installation date: _____________________________ PS Engineering, Inc. 2011 © Copyright Notice Copyrighted information in this manual is subject to change without notice. PS Engineering reserves the right to improve or change the products or contents of this manual, without notification of any person or agency.
