User Manual

PS Engineering Inc. ®

PAR200A Audio Selector Panel, COM radio Controller and Intercom System

Installation and Operator’s Manual

200-228-0200 Page 2-9 June 2014

Local oscillators and internal signals from entertainment equipment can cause undesired interference with

other aircraft systems. Before takeoff, operate the entertainment devices to determine if there is any adverse

effect within the aircraft systems. If any unusual operation is noted in flight, immediately switch off the

entertainment devices.

All entertainment devices must be switched off for both takeoff and landing.

2.7.2.1 Music 2 Mute (J2 Pin 13 & 14)

Connecting J2 pin 13 to pin 14 (or ground) through a SPST switch places the music #2 music source into

the Karaoke Mode. In this mode, incoming music and intercom conversation will not mute the music for

the passengers’ intercom net. This allows uninterrupted music during casual conversation.

2.8 Adjustments

The PAR200A is factory adjusted to accommodate the typical requirements for most aircraft configura-

tions. There are three adjustments with access holes through the top cover (see §2.11) that allow the install-

er to tailor the specific functions.

 Unswitched Input 3 Volume, adjust from 50% to 200% of input value. Turn counterclockwise to

increase gain.

 TEL VOL- The received telephone volume. The unit is set at the factory for 75% of volume. Turn

Clockwise to increase the TEL receive volume.

 LCD CST: adjusts display contrast to suit individual preferences and ambient light.

 DIP Switches (Mic gain and phone sidetone) – PS Engineering installers should call for the Ser-

vice Aid.

SPR

VOL

US3

VOL

TEL

VOL

LCD

CST

Figure 2-2 – PAR200A Adjustments

DIP Switches

(inside)

Unswitched 3

LCD Contrast 3

TEL VOL