Installation Manual

PS Engineering
MB10 Marker Beacon Receiver
Installation and Operator’s Manual
200-023-0001 Page 1-2 Rev. 9, Sept. 2013
MARKER BEACON RECEIVER:
Frequency:
75 MHz Crystal Controlled
Sensitivity:
Low:
High:
Capable of: (preset at factory for field application)
1000 Volts (Hard) (360 to 570 V soft)
200 Volts (Hard) (130 to 200 V soft)
Selectivity:
-6 dB at ±10 kHz
-40 dB at ±120 kHz
External Lamp Output:
7.5 (±4 VDC unloaded, at maximum brightness) VDC
positive when active, max. current 125 mA per lamp out-
put
MM Sense:
Active high (4.5 ± 1.0VDC)
Output impedance:
510
Audio Output: 38 mW <5% THD typical
1.6 EQUIPMENT SUPPLIED
1 ea. of the following units:
Model Description Part Number
MB10 MB10 Marker Beacon Receiver and Indicator. 050-023-0100
MB10R MB10 Marker Beacon Receiver (remote) 050-023-0101
MB10 Installation Kits:
250-023-0100 250-023-0101
Description Quantity Part
Number
Part
Number
DB-15 Female Connector, Solder 1 425-016-0001 425-016-0001
DB-15 Back shell, Plastic 1 425-015-0003 425-015-0003
Screw, Philips, #4-40 x 3/8” Black 2 475-442-0002
Faceplate, MB10 Horizontal 1 575-023-0000
Faceplate, MB10 Vertical 1 575-023-0001
Remote Switch 1 731-004-0005
Sub- D connector Thumb screws 2 475-002-0002 475-002-0002
Mounting Flange 2 430-023-0030
1.7 EQUIPMENT REQUIRED BUT NOT SUPPLIED
a. Circuit Breaker: 1.0 amp
b. Marker Antenna (75 MHz, VSWR 1.5:1, and appropriate for the airspeed) with 50 Ω coax
(RG-58C/U or equiv.)
c. Interconnect Wiring
1.8 LICENSE REQUIREMENTS
None