Owner's Manual

4826 Sterling Drive, Boulder, CO 80301 Owner’s Reference

PH: 720.406.8946 support@psaudio.com www.psaudio.com 15-070-01-1

Rev B

Owner’s Reference

Owner’s Reference BHK Signature Ampliers

Plug in the

connecting cables

Turn on the master

power switch

The BHK Signature Amplier accepts either single ended RCA or balanced XLR connections

to the preamplier or DAC feeding it. Regardless of the cable chosen, the BHK will treat the

incoming signal in such a way that it becomes balanced throughout the amplier’s circuitry.

Our preference for connection to the preamplier is balanced XLR cables. Balanced signals

are lower in noise, provide an extra 6dB of level and take advantage of common mode

rejection. Single ended RCA cables can also be good, but we shy away from their use at

lengths exceeding two meters.

Once connections have been made to both the loudspeakers and the preamplier, it is time

to plug the AC power source in.

BHK ampliers are voltage specic. They operate ONLY at the voltage set at the factory. Do

NOT plug the BHK into a voltage other than what it is set for. Failure to observe this rule may

damage the BHK.

Plug a high quality power cable into the BHK IEC AC inlet, the other end into either a P10

Power Plant, power conditioner, or wall socket of appropriate voltage. Then turn on the

master AC switch.

Plug in the

power cable