Owner's Manual
4826 Sterling Drive, Boulder, CO 80301 Owner’s Reference
PH: 720.406.8946 support@psaudio.com www.psaudio.com 15-070-01-1
Rev B
Owner’s Reference
©2021 PS Audio Inc. All rights reserved.
®
Owner’s Reference BHK Signature Ampliers
Connect the
speaker cables
Biwire
5
With the amplier rmly seated where you have selected, it is time to connect the speaker
cables. The BHK Signature uses custom machined connectors. These connectors were specially
engineered to match the performance specications of the BHK. Each connector is hewn from a
solid block of high purity copper, and machined on a lathe, then hand polished and gold plated.
The connectors can accept standard banana plugs, ¼” spade terminals, or bare wire up to
12AWG.There are two sets for each channel on the Signature 250 and, two sets for the single
mono channel on the Signature 300. Most systems will use only one set of the binding posts to
connect the speaker cable. Use only the nest speaker cables and connectors.
Some may wish to biwire their speakers to the BHK. This practice involves using one shotgun
congured cable or two separate cables. In either case, connect one cable to one set of binding
posts, the other to the second set. On the loudspeaker side, one pair of cables goes to the tweeter
binding posts, the remaining set to the woofer section.