Instruction Manual

4
Installation Introduction
200799_1
Before the product can be installed, consideration will need to be given to routing the power supply to the fire. This will affect
the stages of the installation process. We advise a qualified electrician conduct any electrical parts of the installation.
Note: A single wall socket is required for the operation of the fire, please refer to the separate fire instructions for further
information.
This product has been designed to be installed into a pre-fabricated, or existing Masonry chimney breast.
Please seek advice from a professional, with reference to the structural integrity of the installation site.
If the product is to be installed into a open chimney or flue, it is important that the chimney/flue is blocked off to prevent any
up/down draughts and falling debris which could restrict and alter the airflow of the product.
The product should never be sealed into an opening with the use of silicones or adhesives as this can also alter the airflow and
hinder any future servicing of the product.
It is essential to include a lintel at the required height to ensure the appliance does not support the weight of the finished wall.
A pre-assembled MDF framework has been supplied to ensure that the product is installed at the required minimum internal
clearances for operation. Before commencing with installation please ensure the Fire Support Brackets have been attached to
the MDF framework, these set the minimum depth required for installation- 238mm. As shown in Diagram 1 below.
Diagram 1
Fix the 2 x Fire Support Brackets using 4 x No.8 x15mm Domed-Head Screws into the pre-drilled holes on the MDF
framework . 2 x per bracket.
Fire Support
Brackets
MDF
Framework
For installation into a pre-fabricated chimney breast follow the instructions on Page 5 then continue onto Page 7.
For installation into a existing Masonry chimney breast follow the instruction on Page 6 then continue onto Page 7.
MDF
Framework
H
(mm)
W
(mm)
Volta 42” 518 1102
Volta 32” 518 852
Finished
Opening Size
H
(mm)
W
(mm)
Min Inset
(mm)
Volta 42” 398 1042 Min 238
Volta 32” 398 792 Min 238