Instruction Manual

11
Installation- Fixing the Fire
200799_1
Diagram 14
Finished
Wall
Surface
Finally drill a pilot hole through the locking holes in the Angle Brackets into the MDF Framework behind.
Using 4 x No.8 x15mm Domed-Head Screws fix the fire in position, as shown in Diagram 16.
Diagram 16
Pull the fire forward to the front of the opening and centralise.
Align the tabs on the angle brackets with the face of the finished wall surface, as shown in Diagram 14.
Fix through the slot in each bracket, into the pre-drilled holes in the MDF Framework using 4 x No.8 x15mm Domed-Head
Screws, whilst aligning the tabs with the face of the finished wall surface, as shown in Diagram 15.
Finished
Wall
Surface
Finished
Wall
Surface
Tab
Tab
Diagram 15