Instruction Manual

10
Installation- Magnet Bracket
200799_1
With the fire pushed to the rear of the opening.
Install the Magnet Bracket, as shown in Diagram 12, using the supplied 2 x No.8 x15mm Domed-Head Screws, to fix into the
pre-drilled holes in the MDF Framework, this will ensure the bracket is fitted centrally in the opening.
Before fixing in position align the tabs on either end of the bracket with the face of the finished wall surface, as shown in
Diagram 13.
This will ensure the bracket is installed at the correct distance from the front face for the magnet to engage correctly with the
trim in a later procedure.
Diagram 12
Diagram 13
Finished Wall
Surface
Tab
Tab
Finished Wall
Surface