Instructions

6
Installation – Timber continued
Note: Mantel hooks must be fitted for both floor standing and wall mounted models.
1. Measure from the underside of the hearth to the bottom of the L- bracket fitted on either side of the fire surround and
make a note of this dimension. X detailed on Diagram 3.
2. Measure the internal distance between the surround body and make a note of this dimension. Y detailed on Diagram 3.
3. Working from the centre of the wall bracket- Mark the fixing position of the mantel hooks. X - 28mm and (Y ÷ 2) -10mm, at
either side of the brackets. See Diagram 2.
4. Finally fix the mantel hooks securely in position as indicated in Diagram 2 with the correct fixings for your wall material
(fixings not supplied). See ‘Important Note’ on page 7.
601227_2
3. Hang the fire
Carefully lift the suite and position the pre installed angle brackets,
over the mantel hook brackets. See Diagram 3. Then lower the suite
down to rest on the wall mount bracket. Great care must be taken
to route the fire power cable correctly as indicated in Diagram 4,
confirming the cable is not crushed or damaged on installation.
The suite should now be correctly positioned.
4. Secure the fire
To secure the suite to the wall mount bracket fix with the
provided screws through the base of the wall mount
bracket up into the suite (see Diagram 5). This will lock
the suite in position.
This completes the wall mounted installation option.
For dressing the logs and fire operation, please refer to
the separate fire instructions.
Diagram 4
Diagram 5
Diagram 3 (all dimension in mm)
(Huxton Model Shown)