Installation and Operation Guide
Table Of Contents
- Chapter 1: Introduction
- 1.1 First steps
- 1.2 Service addresses
- 1.3 About this manual
- Chapter 2: Safety
- 2.1 Safety symbols
- 2.2 Information for the system operator
- 2.3 Information for operating personnel
- 2.4 Intended use
- 2.5 Residual risks and safety measures
- Declaration of conformity
- Certifications
- Chapter 3: Technical data
- Chapter 4: System description
- 4.1 VIBCONNECT RF bridge
- 4.2 VIBCONNECT RF sensor unit
- 4.3 VIBCONNECT RF sensor
- Chapter 5: Installation & commissioning
- 5.1 Quick guide
- 5.2 Configuration in OMNITREND
- 5.3 Installation & commissioning of bridge
- 5.4 Installation & commissioning of sensor unit
- 5.5 Installation of sensors
- 5.6 Configuration in OMNITREND (continued)
- 5.7 Installing additional sensor unit
- Chapter 6: Maintenance
- 6.1 Cleaning
- 6.2 System time correction
- 6.3 Installation report
- 6.4 Battery-powered sensor unit
- 6.5 Update
- 6.6 Warranty
- 6.7 Spare parts and accessories
- Chapter 7: Troubleshooting
- Chapter 8: After use
64
VIBCONNECT RF 05.2012
Chapter 6: Maintenance
VIBCONNECT RF is an electronic measuring system that must be
handled with care.
6.1 Cleaning
If required, clean the housings of the bridges and the sensor units
with a damp cloth so that the system component details (serial
number, MAC address) remain clearly visible at all times. Replace
damaged cables without delay.
6.2 System time correction
The system time on the bridge should be checked regularly about
every 6 months and if necessary readjust. Connect to the Bridge
and select 'Set System Time' in the main menu (see also '5.3.1
Changing IP address of bridge', page 32).
6.3 Installation report
The installation report contains a list of all measurement locations
in the database that are monitored through the VIBCONNECT
RF system. The report can be printed and contains the following
information:
• Measurement location with path in machine tree
• Assigned sensor unit including MAC address
• Assigned bridge
This report facilitates the identification of system components on
site, for example for maintenance work.
• In the main menu, select <Tools> / <Reports> / <VIBCONNECT
RF Installation>.
Maintenance