Installation and Operation Guide

59
VIBCONNECT RF 05.2012
1B-8F-DC-4C-00-36
1B-8F-DC-4C-00-38
Channel 1
Channel 3
Channel 2
Channel 4
Procedure
• In OMNITREND, open the Machinery Manager.
• Select one of the previously set up online measurement locations
(see also '5.2.2 Setting up the database', page 30).
• Call up the ‘Meas. Data’ tab.
• In the ‘Meas. Point Type’ section, first select the bridge with the
best reception in the ‘Online Device’ field.
• In the second field, select the sensor unit that is installed at the
respective measurement location (refer to the measurement
location report).
• In the ‘Channel no.’ field, enter the channel number as noted
in the measurement location report for this sensor unit (see also
'5.4.4 Connecting sensor unit', page 45).
• Repeat the above steps for all other measurement locations.
Installation and commissioning
Assignment of sensor
unit, channel and
measurement locations in
the measurement location
report
= “RF Sensor Unit 0”
Assignment of bridge,
sensor unit and channel
in the OMNITREND
database
Bridge
Sensor unit
Channel