Installation and Operation Guide
Table Of Contents
- Chapter 1: Introduction
- 1.1 First steps
- 1.2 Service addresses
- 1.3 About this manual
- Chapter 2: Safety
- 2.1 Safety symbols
- 2.2 Information for the system operator
- 2.3 Information for operating personnel
- 2.4 Intended use
- 2.5 Residual risks and safety measures
- Declaration of conformity
- Certifications
- Chapter 3: Technical data
- Chapter 4: System description
- 4.1 VIBCONNECT RF bridge
- 4.2 VIBCONNECT RF sensor unit
- 4.3 VIBCONNECT RF sensor
- Chapter 5: Installation & commissioning
- 5.1 Quick guide
- 5.2 Configuration in OMNITREND
- 5.3 Installation & commissioning of bridge
- 5.4 Installation & commissioning of sensor unit
- 5.5 Installation of sensors
- 5.6 Configuration in OMNITREND (continued)
- 5.7 Installing additional sensor unit
- Chapter 6: Maintenance
- 6.1 Cleaning
- 6.2 System time correction
- 6.3 Installation report
- 6.4 Battery-powered sensor unit
- 6.5 Update
- 6.6 Warranty
- 6.7 Spare parts and accessories
- Chapter 7: Troubleshooting
- Chapter 8: After use
49
VIBCONNECT RF 05.2012
> 15
Ø 27
0.5±2
> 12
M8
90°
Mounting sensor with screw adapter
tools and auxiliary equiPment
• Power drill with two drill bits (3.5 / 6.8 mm) and depth gauge
• Spot facer
• M8 bottoming tap
• Size 19 torque spanner
• Compressed air to clean mounting point
installation
Select drilling point:
• The minimum distance between the drill hole and the protruding
edges of the sensor housing is 35 mm. Ensure that there is suf-
ficient space for the socket wrench used to tighten the adapter.
Drill hole:
• Using the 3.5 mm drill bit with depth gauge, pre-drill a hole of
> 15 mm.
• Drill out hole with 6.8 mm drill bit.
• Face the drill hole with the spot facer (depth: approx. 1 mm).
• Cut the thread (M8), thread length: > 12 mm.
Note
Ensure that it is permissible to
drill a hole at the selected loca-
tion. For instructions, contact the
machine manufacturer or refer
to the machine documentation.
Installation and commissioning
adhesive
VIB 3.418
magnetic
VIB 3.423
screwed (M8)
VIB 3.480, standard
Drilling and facing hole,
cutting thread