Installation and Operation Guide

ManualsBrandsPRÜFTECHNIK Condition Monitoring ManualsElectronicsVIB CONNECT RF Bridge / Industrial Data Acquisition System

Table Of Contents

Chapter 1: Introduction
1.1 First steps
1.2 Service addresses
1.3 About this manual
Chapter 2: Safety
2.1 Safety symbols
2.2 Information for the system operator
2.3 Information for operating personnel
- Qualification
- Personal protective equipment
- Rules for normal operation
2.4 Intended use
2.5 Residual risks and safety measures
Declaration of conformity
Certifications
Chapter 3: Technical data
Chapter 4: System description
4.1 VIBCONNECT RF bridge
4.2 VIBCONNECT RF sensor unit
- 4.2.1 Power options
- 4.2.2 Operating cycle: measuring, sending, idling
- 4.2.4 Topology of radio cell
4.3 VIBCONNECT RF sensor
Chapter 5: Installation & commissioning
5.1 Quick guide
5.2 Configuration in OMNITREND
- 5.2.1 Installing and registering device drivers
- 5.2.2 Setting up the database
- 5.2.3 Creating and printing measurement location report
5.3 Installation & commissioning of bridge
- 5.3.1 Changing IP address of bridge
- 5.3.2 Installation preparations
- 5.3.3 Mounting bridge
- 5.3.4 Connecting bridge
- 5.3.5 Commissioning bridge
- 5.3.6 Overview of connections and interfaces
5.4 Installation & commissioning of sensor unit
- 5.4.1 Overview of connections and interfaces
- 5.4.2 Measuring reception field strength at location of installation
- 5.4.3 Mounting sensor unit
- 5.4.4 Connecting sensor unit
- 5.4.5 Commissioning sensor unit
5.5 Installation of sensors
- 5.5.1 Choosing the measurement locations
- 5.5.2 Mounting sensor
- 5.5.3 Installing and connecting sensor line to sensor unit
5.6 Configuration in OMNITREND (continued)
- 5.6.1 Registering bridge in OMNITREND
- 5.6.2 Registering sensor units in OMNITREND
- 5.6.3 Assigning measurement locations in the database to a sensor unit and bridge
- 5.6.4 Creating measuring configuration
- 5.6.5 Loading measuring configurations to the bridge
- 5.6.6 Importing measurement data in OMNITREND
5.7 Installing additional sensor unit
Chapter 6: Maintenance
6.1 Cleaning
6.2 System time correction
6.3 Installation report
6.4 Battery-powered sensor unit
- 6.4.1 Battery status
- 6.4.2 Changing battery
6.5 Update
6.6 Warranty
6.7 Spare parts and accessories
Chapter 7: Troubleshooting
Chapter 8: After use
- Decommissioning
- Disposal

VIBCONNECT RF 05.2012

Installation and commissioning

5.4.1 Overview of connections and interfaces

Battery-powered sensor unit

* the 24 V version is equipped with a

second terminal strip for power supply

1. Antenna

2. Cover ﬁxtures (Allen screws)

3. Lithium batteries

4. Terminal strip*

5. Cable gland for sensor line

6. Cable gland for 24V power

cable / energy harvester cable

7. Mounting ﬂaps for sensor unit

8. Vibration dampers