Installation and Operation Guide

The product described in this document, and the
content of this manual are protected by intellectual
property laws. All rights reserved. The manual may
not be copied, reproduced, translated or made
accessible to a third party in any form, neither in its
entirety nor as an excerpt.
No liability may be claimed against the publisher
regarding the product described in this manual.
The author assumes no liability for accuracy of the
manual contents. The author shall not be liable for
any direct or indirect damage of any kind resulting
from use of the product or the manual, even if the
publisher has expressly indicated the potential for
occurrence of such damage.
The manufacturer shall not be liable for product
defects. This warranty and liability limitation also
applies to sales partners and distributors.
All registered trademarks referred to in this manual
are the property of the respective owners. This
applies also to trademarks that are not specifically
denoted as such.
© PRÜFTECHNIK Condition Monitoring.
All rights reserved.
Compliance Statement acc. to Sect. 15.19:
This device complies with Part 15 of the FCC
Rules.Operation is subject to the following two
conditions:
(1) this device may not cause harmful interfer-
ence, and (2) this device must accept any interfer-
ence received, including interference that may cause
undesired operation.
Le présent appareil est conforme aux CNR d'Indus-
trie Canada applicables aux appareils radio exempts
de licence. L'exploitation est autorisée aux deux
conditions suivantes : (1) l'appareil ne doit pas pro-
duire de brouillage, et (2) l'utilisateur de l'appareil
doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compro-
mettre le fonctionnement.
User Information acc. to Sect.15.21:
Changes or modifications not expressly approved by
the party responsible for compliance could void the
user’s authority to operate the equipment.
Class B Statement Sect. 15.105 –)
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment gener-
ates, uses and can radiate radio frequency
energy and, if not installed and used in accordance
with the instructions, may cause harmful interfer-
ence to radio communications. However, there is
no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct
the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equip-
ment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the re-
ceiver is connected.
• Consult the dealer or an experienced radio/ TV
technician for help.
Legal notes
Statement acc. to RSS-Gen 7.1.2
Under Industry Canada regulations, this radio
transmitter may only operate using an antenna
of a type and maximum (or lesser) gain ap-
proved for the transmitter by Industry Canada.
To reduce potential radio interference to other
users, the antenna type and its gain should
be so chosen that the equivalent isotropically
radiated power (e.i.r.p.) is not more than that
necessary for successful communication