Installation and Operation Guide

8
VIBCONNECT RF 05.2012
• All operating personnel have been instructed in the relevant
occupational safety and environmental protection issues in rela-
tion to the system, and in the use of this manual, with particular
reference to the safety instructions
• The responsibilities for installation, commissioning and opera-
tion have been assigned
Compliance with operating manual
You must ensure that
• This manual has been read and fully understood by all operating
personnel, and that all instructions are strictly adhered to
• A copy of the manual is filed near the system and accessible at
all times to the operating personnel
• The manual is handed over to any future owner of the system
Training
You must instruct the operating personnel on a regular basis on
the application of all safety instructions. It is your duty to ensure
that all safety instructions are strictly adhered to.
You must also instruct your personnel to comply with all statutory
and other binding safety and accident prevention regulations and
ensure that all warnings are observed.
As the system operator, you must ensure that all personnel work
with due regard to safety.
2.3 Information for operating personnel
Qualification
The system must be commissioned and operated by properly in-
structed and authorized personnel. Installation and dismantling
must be performed by a qualified electrician. All operating person-
nel must have read and fully understood the operating manual and
must follow all instructions in the manual.
Personal protective equipment
All personnel involved in the installation and dismantling of the
system must wear hard hats and protective goggles. No personal
protective equipment is required for the operation of the system.
Rules for normal operation
The operating status of the bridge is indicated by the LED at the
power supply. During normal operation, the LED is lit in green; if
there is a power failure, the LED is off.
Safety