User's Manual

Soft foot
Soft foot measurement can be started from any screen where the 'Soft foot' icon [ ] is active.
Tap
to start soft foot measurement. The laser beam must be centered. Refer to Laser beam
adjustment.
Tap any one of the four pulsating value fields to start soft foot measurement at the respective machine
foot.
Loosen the corresponding foot bolt (see hint 2). The recorded soft foot value is displayed [1]. When
the soft foot value stabilizes, tap the 'Proceed' icon, then tighten the bolt (see hint 2). If desired,
the soft foot measurement at the corresponding foot is canceled by tapping the 'Cancel' icon.
The above soft foot measurement procedure is repeated for all four feet positions.
FictionSoft 25
(Undefined variable: General.UserGuideTitle)