Safety Manual
en
Do not look directly into the laser beam at any time. (The
natural blink reaction of the human eye is normally sufficient
to protect the eyes from any dangers posed by looking at the
laser beam briefly. But as natural blink reaction may fail to
occur, care should be taken to avoid staring into the beam.)
Do not insert any optical devices into the beam path.
The LED on the front of sensALIGN laser illuminates whenever
the laser beam is emitted.
CAUTION – Use of controls or adjustments or performance
of procedures other than those specified herein may result in
hazardous radiation exposure.
To prevent eye damage and personal injury:
Do not point laser directly at persons or animals or indirectly
off reflective surfaces.
Do not look directly into the laser with optical tools (for
example : binoculars, telescopes, microscopes). Optical tools
can focus the laser and be dangerous to the eye.
Use the system only as specified or hazardous laser radiation
exposure can occur.
Do not open the system. The laser beam is dangerous to eyes.
Have the system repaired only through an approved technical
site.
General safety
To prevent possible electrical shock, fire, or personal injury:
Read all safety information before you use the system.
Carefully read all instructions.
Use the system only as specified, or the protection supplied
by the system can be compromised.
Make sure machines are locked out, tagged out, and cannot
be started accidentally or deliberately during maintenance.
Do not use the system around explosive gas or vapour.
Use only the external mains power supply included with the
system.
Do not charge the system while inside its carrying case.
Do not use the system if it operates incorrectly.
Use only specified replacement parts.
Have an authorized PRÜFTECHNIK service centre repair the
system.
Handling precautions
ROTALIGN touch and the sensALIGN heads (sensor and laser) are
precision instruments and should not be dropped or subjected to
physical shock.
Storage
Use the provided case to transport ROTALIGN touch and its related
components. If the sensALIGN heads are mounted on standard
brackets while within the case, the clamping levers must remain in
the “open” position and not locked.
If the system is not used for an extended period, remove the related
lithium-ion batteries from the components and store both the
batteries and the components in a cool, dry and well-ventilated
location.
Observe the storage temperatures and humidity specified in the
“Safety specifications” section.
WARNING
WARNING
WARNING
CAUTION