User's Manual

User Manual v1.6 12
Printed copies of this document are uncontrolled
6.0 Certifications
6.1 FCC
Tune up power table BLE / WLAN
- Each product is programmed with the pre-defined RF parameters
- Each product RF power level is measured to ensure the power level not exceeding the
target power level, in a fully calibrated setup.
- The user has no possibility to change these settings later on
Please find below the Maximum Transmit Power for production units:
<For Type1LD>
Band / Mode
Average Power (dBm)
LE
GFSK
Bluetooth 7
Band / Channel / Frequency (MHz)
IEEE 802.11 Average Power (dBm)
11b
11g
HT20
2.4GHz WLAN
17
17
17
<For XRBH-1>
Band / Mode
Average Power (dBm)
LE
GFSK
Bluetooth 5
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.