ProxxonTools.com Professional Grinder IB/E Manual 3080767 Conforms to ANSI/UL 60745-1 ANSI/UL 60745-2-1 Certified to CAN/CSA-C22.2 No. 60745-1-04 CAN/CSA-C22.2 No.
-2-
23 0 dö V jfkd gj ida sdgb 3 VA dlg jd ,dl sgj g d dö 3 dg fjdkg VA fdl fjk fg dlf 12 12 VA 12 VA VA 9 Fig. 3 Fig. 1 23 12 12 VA 12 VA VA dö 0 V jf dlf kdg ida j sd 3 dlg gb VA ,dl jdsg g d j dö dg fjd 3 VA fdl kg fg fjk 9$ 9$ 9$ G| MI GOI NGJ LGD M VGJ GOJ EM 9$ GOJ GVJM G G|I GJI MG 9$ GO NJI IJ MN 1 Fig. 2 3 VAfjk 3 VA gj döfjdkg l fg bjds 230 V kdgj sdg dlg d dgfd döjf dlfida dlg, 12 VA VA 12 VA 12 Fig.
PROXXON – Professional Grinder IB/E Dear Customer, Before putting the machine into operation, read the enclosed safety rules and operating instructions. General Safety Rules Warning! Read and understand all instructions. Failure to follow all instructions listed below, may result in electric shock, fire and/or serious personal injury. Save these instructions. Dress properly. Do not wear loose clothing or jewelry. Contain long hair. Keep your hair, clothing, and gloves away from moving parts.
Tool service must be performed only by qualified repair personnel. Service or maintenance performed by unqualified personnel could result in a risk of injury. the spinning wire brush away from you. Small particles and tiny wire fragments may be discharged at high velocity during the „cleaning“ action with these brushes and may become embedded in your skin. Bristles or wires will be discharged from the brush at high speeds. When servicing a tool, use only identical replacement parts.
Do not grind or sand near flammable materials. Sparks from the wheel could ignite these materials. This product is not intended for use as a dental drill or in medical applications. Serious personal injury may result. Do not touch the bit or collet after use. After use the bit and collet are too hot to be touched by bare hands. When using steel saws, cut-off wheels, high speed cutters or tungsten carbide cutters, always have the work securely clamped.
Technical data Length: Weight: Collar: Motor Voltage: Rotary speed: Characteristic noise emission Noise level may exceed 85 dB(A) during operation. Ear protection must be worn! Vibration at handle approx. 9 ”(250 mm) approx. 1,1lb (500g) Ø 3/4 ” (20 mm) 115 V~, 50-60 Hz 5,000 - 20,000 rpm ≤ 70 dB (A) the cap nut is lowered into the machine housing. The use of a chuck is therefore not possible. Maintenance : Warning! Disconnect the plug from the mains before performing any maintenance or cleaning work.
