ProxxonTools.
19 1 2 3 4 8 5 6 0 1 2 5 3 4 7 9 14 13 11 Fig. 1 12 10 0 1 2 5 3 4 1 3 2 4 Fig. 2 Fig. 3 Fig. 4 -2- Fig.
2 1 1 3 2 Fig. 6 Fig. 7 Fig. 8 Fig. 9 1 2 Fig. 10 -3- Fig.
Operating Instructions DB 250 Instructions for the use of the Micro wood turning lathe DB 250 Dear Customer, In order to be able to operate the wood turning lathe safely and correctly, please carefully read the following safety and operating instructions prior to use. This instruction manual covers: • safety regulations • operation and maintenance • spare parts list Please read carefully and become familiar with this entire instructions manual.
Additional safety instructions for wood lathes: Table 1: Minimum gage for cord: Total length of cord in feet 25 ft 50 ft 100 ft 150 ft AWG: 18 16 16 14 Additional safety instructions: • Ensure the workplace is tidy. • Check the unit for damage before use• (connection cable, protective devices, etc.), have defective parts replaced by qualified personnel. • This unit corresponds to the pertinent safety regulations. Repairs (e.g.
Technical data METAL SCREW COVER OF GROUNDED OUTLET BOX GROUNDING PIN Weight: Noise emission: ADAPTER GROUNDING MEANS Voltage: Power rating: Speed: Centre distance: Centre height: Spindle ciearance: Dimensions: GROUNDING PIN 115 Volt, 50/60Hz 100 W 1.000-5.000/min ca. 250 mm (9 27/32” in.) 40 mm (1 37/64” in.) 10 mm (13/32” in.) ca. 490 x 150 x 95 mm (19,29 x 5,91 x 3,74 in.) 2.
Clamping of long workpieces (thicker than 10 mm) 1. Insert drive spike 1 (fig. 7) in the drive spindle and screw it tight (as described in the clamping of round rod). 2. Push tailstock up to the back end of the workpiece as shown' in fig. 8 and clamp it fast to the bed with the knurled nut, exactly as described in the previous section. 3. Turn the knurled nut to bring the point into contact with the workpiece so that it is fixed 4.
