THUNDER STRIKE - P16-41460 4CH Indoor Helicopter w/ Gyro User’s Manual Ages 14+ and up
TABLE OF CONTENTS What’s in the Box.................................................................................................... 3 Helicopter Part List................................................................................................. 4 Infrared Control Transmitter.................................................................................... 4 Installing the Batteries............................................................................................
WHAT’S IN THE BOX a.- (1) Helicopter e.- (1) Spare Balance Bar b.- (1) Remote Control f.- (1) Spare Ascend and Descend Landing Gear c.- (4) Spare Screws g.- (2) Spare Tail Blades d.- (2) Spare Main Blades h.
HELICOPTER PART LIST Specifications Size: 7.87”x1.37”x4.13” Main Rotor: 6.81” Battery: Li-poly 3.
INSTALLING THE BATTERIES 1. Turn the remote control over to access the battery compartment on the back. 2. Remove the screw and remove the battery compartment cover 3. Insert 6 AA batteries making sure to orient them according to the illustrations on the inside of the battery compartment. 4. Replace the cover ensuring to fasten the screw. Battery Notes: • Do not mix new and old batteries or different brands of batteries.
CHARGING THE HELICOPTER • Make sure to switch OFF the helicopter prior to charging. • Use the remote control’s charging cable located behind the front panel OR use the included USB cable to charge the helicopter using any available USB power port. Charging Socket Charging Cable Power Switch Battery Notes: • Do not use or leave the battery near a heat source such as fire or heater. • Do not allow the battery to be immersed in water. Make sure to keep the battery in a cool and dry environment.
PRE-FLIGHT 1. Lay your helicopter on the ground at least 6 feet away from obstructions, animals or people. 2. Move the helicopter’s power switch located in the main housing to ON and make sure the throttle on the remote is in the down position. 3. Stand back, and switch the remote’s power switch to ON. 4. Increase pressure on the throttle stick until the helicopter is able to just barely hover over the floor. 5.
Notes: • Do not fly in extreme temperatures above 113°F/45° C, or below 50° F/10° C as doing so will affect performance and may damage the helicopter. • Do not fly in strong wind as windy conditions will limit control ability. • Select a large, wide-open area and make sure there are no obstructions, animals or people nearby. • If your helicopter is heading for a collision with a spectator or hard object, cut the throttle to prevent damage. • If there is not enough power to lift off your battery may be low.
TROUBLESHOOTING PROBLEM CAUSE CHECK THIS The remote control doesn’t work The power switch on the remote control is OFF Make sure the Power switch is set to is ON The batteries are improperly inserted Confirm batteries are correctly inserted.
CARE AND MAINTENANCE Warning 1. Recommended for indoor use only, and only in rooms without obstacles, breakable objects or fans. 2. If the helicopter becomes damaged or broken do not fly as it may lead to injury. FCC INFORMATION This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) This device may not cause harmful interference. 2) This device must accept any interference received including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Proximus Products 8300 West Flager St. Suite# 121-106 Miami, FL 33144 Technical Support: 1(888) 222-5487 Proximus™ is a registered Trademark of Streak Products, Inc. © 2011 Streak Products, Inc.
