User`s manual

Setting up Your Tower Speaker

Attaching the Base

Powering Up

Time Setup

1. Carefully take the tower body

and base out of the packaging.

2. Locate and set aside the

screws and washers.

3. Attach the base to the body

aligning the three holes in the

base with three holes on the

tower.

4. Screw the base into the body.

5. Stand the tower upright on the floor. The device is now ready for

use.

Place the unit in the desired position and unravel the main power

cable. Insert the cable into the power supply, connect the power

supply to the wall and ensure the power switch on the back of the

device is in the ON position.

After the unit is plugged into the power supply

for the first time or if there is a power failure,

the LCD display read “0:00”. In order to set the

clock to the current time, the device needs to

be in standby mode.

1. Press MEM/TIME button, the digits on the display will blink

intermittently.

2 .Press the PREVIOUS/NEXT button repeatedly until the correct

hour is set. Press the MEM/TIME to confirm.

12:00