iPod / iPhone Tower Speaker P16-41487 User’s Manual All brand names and trademarks are properties of their respective owners.
Getting Started Remove the speaker from the box and remove any packaging material from the product. In the Box • Speaker unit • Stand and screws to attach the unit • Remote control • Instruction manual • AC adapter • Power cable Safety Instructions When using electrical devices, basic safety precautions should always be followed. This device is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of experience or knowledge.
This device is intended for household use only and should not be used for industrial or commercial purposes. Do not operate this device with a damaged plug or cord, after a malfunction or after being dropped or damaged in any way. Do not use this device for anything other than its intended use. This device must be placed on a stable, heat resistant surface. Do not push objects into any openings as damage to the device and/or electric shock may occur. Do not use this product in wet or bad weather conditions.
Port Diagrams Top Panel 1. iPhone / iPod Dock 2. Standby 3. Function 4. Previous Track 5. Next Track 6. Volume 7. Play/Pause 8. Volume + 1 2 3 4 STANDBY FUNCTION 5 6 VOL 7 8 Back Panel 1. Video Out 2. Left/Right Line In 3. 3.5mm Audio In 4.
Remote Control 1. Power 2. Sleep 3. Mute 4. iPod Menu 5. Menu Up 6. Source 7. Previous Track 8. Enter 9. Next Track 10. Memory and Time Set 11. Menu Down 12. Pause/Play 13. Treble + 14. Bass + 15. Volume + 16. Treble 17. Bass 18.
Setting up Your Tower Speaker Attaching the Base 1. Carefully take the tower body and base out of the packaging. 2. Locate and set aside the screws and washers. 3. Attach the base to the body aligning the three holes in the base with three holes on the tower. 4. Screw the base into the body. 5. Stand the tower upright on the floor. The device is now ready for use. Powering Up Place the unit in the desired position and unravel the main power cable.
3. The minute digits on the display will now blink. Repeat the above process until correct minute is set. Press the MEM/TIME to confirm the minute setting. 4. You can also connect your iPhone or iPod to the device and power it on, the display will automatically sync the time with the iPhone or iPod. Setting Alarm 1. Press and hold MEN/TIME button in shutdown state, the display will flash ON/OFF to select setting alarm or canceling alarm. 2. Press PREVIOUS /NEXT to select ON, and the display will blink.
Sleep Mode Press the SLEEP button, the display will then blink intermittently. Continue to press the button until the display shows the time you would like to set. It is possible to set from 10 to 90 minutes. The display will blinks three times to confirm the sleep setting, and then return to the interface. If you want to cancel the sleep mode, press the SLEEP button until 00 is read on the display. After it blinks three times, the sleep mode will be cancelled. Playing Music on your iPhone or iPod 1.
Line-In Jack Requires a 3.5mm cable (not included). 1. Connect the 3.5mm cable to the Aux in jack. Connect the other end of the 3.5mm cable to any available audio source. 2. Press the power button to turn the device on. 3. Press the function button or source button on the remote to switch to Line-In mode labeled “L IN”. 4. Use the controls on the connected device to begin playing audio. L in AUX-In Auxiliary Input RCA Requires an RCA cable (not included). 1.
Care and Maintenance • It is recommended to unplug the device when not in use. • Do not play music at excessive volume levels as damage to hearing and/or the equipment may occur. • Do not use this unit in wet or damp conditions. • Always disconnect the unit from the mains power supply before cleaning. Clean the appliance with a soft, damp, lint free cloth. Do not use abrasives or harsh cleaners.
Proximus Products 8300 West Flager St. Suite# 121-106 Miami, FL 33144 Technical Support: 1(888) 222-5487 Proximus™ is a registered Trademark of Streak Products, Inc. © 2011 Streak Products, Inc.
