Service manual

CP-SX1350(P5SX+)

4. Wiring of the bottom case when the exhaust fan holder is mounted to it.

A84

Right speaker

#3055

Attach the leads to the exhaust fan

as per the assembly diagram.

Pass the exhaust fan leads through

the notch in the duct.

Pass the TSW leads through the

notch in the ballast holder.

Before attaching the exhaust fan duct, send the TSW

leads from the side behind the duct, install the TSW first

then the fan duct. Surplus leads cannot be left inside the

duct, so pass them through the side of the ballast holder.

Verify the type of TSW, and install it so that stamped

designation is visible.

(YS11A120A)

Push the TSW (lamp temperature switch) into its fitting

until a click can be heard.

TSW

Wiring diagram 5