Service manual

34
CP-SX1350(P5SX+)
CNTH
CNBAR
#3054
lead
3. Wiring of bottom case when the power block is mounted to it.
TSW
CNPW2 CNPW1
Make sure that the three kinds of cables
come out the side of the power block as
per the diagram.
Wire the lamp leads by passing
them underneath the lamp housing.
Secure the connectors for the lamp leads to the lamp housings.
When doing so pay attention to the polarity of the connectors.
If the lamp leads are too long, push the surplus length up into
the empty space beneath the connectors.
Wiring diagram 4
Lamp
lead