Specifications

Maintenance 4-1
Chapter 4
Maintenance
CHANGING THE LAMP
Follow these steps to change the lamp when the primary bulb burns out:
1 Press the key to turn the lamp off. Allow the fans to cool the lamp
until the fans stop.
2 Turn the projector on its back.
3 Lift the tab and pull the lamp assembly up and out. Rotate the assembly
and place it back in the projector.
Figure 4-1 Changing the lamp
NOTE: Some lamps may fail without turning on the indicator. If the lamp
fails and the indicator glows, allow the fans to cool the projector until
they stop. If the lamp fails but the indicator does not go on, press the
key to turn the lamp circuit off. Then, allow the fans to cool the projector until
it stops.