User's Manual
Table Of Contents
- COPYRIGHT
- TRADEMARKS
- FCC COMPLIANCE
- Chapter 1. Overview
- Chapter 2. Installation
- Chapter 3. Management Overview
- Chapter 4. Basic Management
- Chapter 5. Web Interface
- Chapter 6. Command Line Interface
- Chapter 7. Procedures
- Appendix A. Specifications
- Appendix B. Troubleshooting
- Appendix C. Support and Contacts
- Glossary
Tsunami MP.11and MP.11a Installation and Management
HyperTerminal Connection Problems
The serial connection properties can be found in HyperTerminal as follows:
1. Start HyperTerminal and select Properties from the File menu.
2. Select Direct to Com 1 in the Connect using: drop-down list (depending upon the COM port you
use); then click Configure. A window such as the following is displayed:
3. Make the necessary changes and click OK.
4. Click the Settings tab and then ASCII Setup…. A window similar to the following is displayed:
5. Ensure that Send line ends with line feeds is selected and click OK twice. HyperTerminal is now
correctly configured.
Appendix B. Troubleshooting 113
CPN 65755B Issue Date: August 2003