User's Manual
Table Of Contents
- COPYRIGHT
- TRADEMARKS
- FCC COMPLIANCE
- Chapter 1. Overview
- Chapter 2. Installation
- Chapter 3. Management Overview
- Chapter 4. Basic Management
- Chapter 5. Web Interface
- Chapter 6. Command Line Interface
- Chapter 7. Procedures
- Appendix A. Specifications
- Appendix B. Troubleshooting
- Appendix C. Support and Contacts
- Glossary
Tsunami MP.11and MP.11a Installation and Management
Enabling, Disabling, or Deleting a Table Row
You can also enable, disable, or delete a row in a table. The syntax of this command is:
<table name> <row> <enable/disable/delete>, or
<table name> <row> status <1/2/3>
Example 1: The following command enables the row at index 2 of the SNMP IP access table
(snmpipaccesstbl).
set snmpipaccesstbl 2 enable
Example 2: The following command disables the row at index 2 of the SNMP IP access table
(snmpipaccesstbl). The status codes have the following meaning: 1 is enable, 2 is disable, 3 is
delete.
set snmpipaccesstbl 2 status 2
Chapter 6. Command Line Interface 101
CPN 65755 Issue Date: August 2003