User`s guide

74
The following table illustrates the state of the LEDs during power-up:
etatSDELsutatSDELoidaRDELenobkcaB
ffotinUffOffOffO
nO-rewoP
scitsongaiD
wolleYffOffO
scitsongaiD
deliaF
deRffOffO
TesaB01oN
detceteDkniL
wolleYknilBffOffO
lamroNneerGwolleYgniknilBneerGgniknilB
There are three functional LEDs on the back panel of the RangeLAN2 Access Point:
❑ The cornermost green LED should be on steady when the Access Point is a Master.
❑ The green LED nearest the 10BaseT connector is on steady when a functional
10BaseT cable is plugged in. It will not light if you are using 10Base2 cable.
❑ The third LED is on steady when an Access Point configured as a Station is syn-
chronized to a Master.
Figure 16
Back Panel LEDs
10BaseT Link Indicator
Synchronized to Master LED
Master LED