User`s guide

The RangeLAN2 752x Access Point supports the following MIBs:

❑ MIB-II (RFC 1213)

❑ IEEE 802.1d Bridge MIB (RFC 1493)

❑ Extended Ethernet MIB (RFC 1643)

❑ Proxim Enterprise MIB

The Proxim Enterprise MIB is supplied in ASN.1 format. It is available on the

Proxim BBS and Web site. The filename is AP7520.MIB. Follow the instruc-

tions in your SNMP management package for incorporating enterprise-specific

MIBs.

Note:

The RangeLAN2 Access Point is not manufactured with a default IP address.

In order to SNMP manage the RangeLAN2 Access Point, you must first assign

it a valid IP address for your network using null modem cable configuration

or a BOOTP server.

You may choose to configure the RangeLAN2 752x Access Point through the menu

trees (in-band or out-of-band) to set SNMP parameters before using an SNMP manager.

Enable/Disable SNMP allows you to enable or disable SNMP management of

the RangeLAN2 752x Access Point.

The Read-Only SNMP Community parameter specifies a community sup-

ported by the RangeLAN2 752x Access Point. Actions permitted by this

community are “read-only” (GET and GET-NEXT). SET attempts using this

community will result in rejection of the attempt with a general error response

and the generation of an authentication trap (if so enabled).

The Read-Only SNMP Manager IP Address specifies the IP address of the

SNMP manager which is permitted to use the Read-Only SNMP Community.

An address of 0.0.0.0 indicates any manager may use this community.