User`s guide

6. Configuration Parameters

To configure the RangeLAN2 Access Point, choose the Configuration option from the

Main Menu. The following two diagrams illustrate the software tree:

** RangeLAN2 752x only

+ Not Accessible via Telnet

Dotted Line - Visible when configured as Master

Dashed Line - Visible when configured as Station

IP Address Subnet Mask Default Gateway Address Send BOOTP at Boot Time

BOOTP Server (0.0.0.0 for Broadcast) Telnet Access Telnet Password ** Browser Management

** Browser User Name ** Browser Password

TCP/IP Configuration Menu

Filter Fixed Nodes Filter IP Packets Filter IPX Packets Filter NetBEUI Packets

Filter AppleTalk Packets Filter DECNet Packets Filter Other Packets Filter IPX RIP Broadcast Packets

Filter IPX SAP Broadcast Packets Filter IPX LSP Broadcast Packets Filter ARP Broadcast Packets ARP Filter Network Address

ARP Filter Subnet Mask Filter MAC Multicast Packets MAC Filter Address MAC Filter Subnet Mask

Broadcast Bandwidth Allocation %

Filter Configuration Menu

Aging Period (seconds) ** Forwarding DB Usage Trap Threshold (%)

Bridge Configuration Menu

Radio Port Administrative Status Configured Domain Configured C hannel C onfigured Subchannel

Configured Station Type Configured First Master To Sync To Configured Master Name Configured Error Dom ain

Repeating Enabled Delay Radio Reconfigure Roam Config Roaming Enabled

MAC Optimize ** No Traffic Trap Period (seconds) ** Radio Traffic Trap Threshold (%) ** Radio Broadcast Trap Threshold (%)

Set Security ID Reset Radio

Radio Configuration Menu

10BaseT Link Monitor Ethernet Port Administrative Status

Ethernet Configuration Menu

** Authorization Table Configuration Menu

** SNMP Configuration Menu

** Upload Configuration Menu

+ Reset Access Point to Factory Defaults

Dump Configuration to Screen

Configuration Menu

Statistics Menu

Status Menu

Dow nload Menu

Diagnostics Menu

Reset Access Point