User`s guide

39
The Read/Write SNMP Community parameter specifies the community
supported by the Extension Point. Actions permitted by this community are
“read-write” (GET, GET-NEXT, and SET).
The Read/Write SNMP Manager IP Address specifies the IP address of the
SNMP manager which is permitted to use the Read/Write SNMP Community. An
address of 0.0.0.0 indicates any manager may use the community.
The SNMP Trap Community parameter specifies the community that will be used
by the Extension Point when generating TRAP PDUs (Protocol Data Units) to
remote managers.
The Trap Target Address specifies the IP address of the device to which gener-
ated TRAP PDUs will be sent. A value of 0.0.0.0 disables trap generation.
Authentication Traps are sent to the Trap Target Address whenever anyone
attempts to SNMP manage the Extension Point with an invalid community or from
an invalid community. You may enable or disable the sending of these traps.
SNMP Supported Traps
The following traps are supported by the Extension Point and are sent to the SNMP
manager defined by the Trap Target Address when they occur.
MIB II Traps
Cold Start - Sent when the Extension Point powers on or reboots.
Link Up - Sent by each interface at start-up or after coming back up.
Link Down - Sent when the Extension Point software cannot initialize or communi-
cate with either interface.
Authorization - Sent to the network manager when someone tries to manage an
Extension Point with an invalid community.