User`s guide

The Extension Point supports the following MIBs:

❑ MIB-II (RFC 1213)

❑ IEEE 802.1d Bridge MIB (RFC 1493)

❑ Proxim Enterprise MIB

The Proxim Enterprise MIB is supplied in ASN.1 format. It is available on the

Proxim BBS and Web site. The filename is AP7540.MIB. Follow the instructions

in your SNMP management package for incorporating enterprise-specific MIBs.

Note:

The Extension Point is not manufactured with a default IP address. In order

to SNMP manage the Extension Point, you must first assign it a valid IP

address for your network using null modem cable configuration or a BOOTP

server.

You may choose to configure the Extension Point through the menu trees (in-band or out-of-

band) to set SNMP parameters before using an SNMP manager.

Enable/Disable SNMP allows you to enable or disable SNMP management of

the Extension Point.

The Read-Only SNMP Community parameter specifies a community supported

by the Extension Point. Actions permitted by this community are “read-only” (GET

and GET-NEXT). SET attempts using this community will result in rejection of the

attempt with a general error response and the generation of an authentication trap (if

so enabled).

The Read-Only SNMP Manager IP Address specifies the IP address of the

SNMP manager which is permitted to use the Read-Only SNMP Community. An

address of 0.0.0.0 indicates any manager may use this community.