User`s guide

The First Sync To parameter lists the name of the Master to which this Extension Point

will first look to synchronize. If programmed, there will also be parameters for Second

Sync To and Third Sync To.

The Roaming Enabled parameter can differ from its configured value if any Sync To param-

eters are set. The Roaming Enabled parameter is set to “false” if one or more of these are

programmed, even if the Configuration Menu indicates it is “true.”

If there is a parameter that will not take effect until the Extension Point or Backbone radio is

reset, the Reset Required for Reconfiguration parameter will be set to “true.” For

example, after changing the radio Channel through the Configuration Menu, this parameter

would be set to “true.”

Bridge Status Menu

The Bridge Address is the MAC address of the Extension Point.

TCP/IP Status Menu

The current IP Address, Subnet Mask and Default Gateway are displayed.

Forwarding Database Table

The Extension Point is a learning bridge. Over time, from watching the packets on the

network, the Extension Point determines where the nodes on the network are -- on the BSA

or Backbone side of the Extension Point. You can view the table of nodes known to the

Extension Point. This table can hold a maximum of 2048 entries.