User's Manual

Harmony Utility 34
Link Quality
When the PCI Card is in Infrastructure mode, click the Link Quality tab to view the list
of Access Points within range of the PCI Card, as shown in the following example. You
can perform a link quality test with any of the detected Access Points by clicking the
Transmission Success Rate button.
The Access Point screen reports the following information for each Access Point
detected by the PCI Card:
• AP Address:
This field reports the physical (or MAC) address of the detected
Access Point.
• SSID: This field reports the detected Access Point’s SSID or Service Set Identifier.
See “SSID” on page 18 for more information.
• Channel: This field displays the Channel used by the detected Access Point. See
“Channel” on page 20 for more information.
• Signal Strength: This field displays the strength of the radio signal received by
the detected Access Point.