User's Manual

Harmony Utility 26
Station Configuration
Click the Configuration tab to view the Station Configuration screen, shown below.
Edit the configuration parameters as necessary and click Apply to save your changes.
To change the operating Channel, Maximum Send Rate and RTS/CTS settings, click the
button labeled Advanced Configuration to display these parameters, as shown in the
example on the next page.
The configuration parameters are described in Chapter 4 beginning on page 17.
Note that the Channel selection box is unavailable when the Network Mode is set to
Infrastructure. When Network Mode is set to Ad Hoc, you can configure one or more
Channels for the PCI Card to scan. If you select multiple Channels, the PCI Card will
scan each Channel looking for an Ad Hoc network to join that uses the same SSID as
the PCI Card.